Dragón volador, Origami
[ Pobierz całość w formacie PDF ]
Dragon In Flight (Version 2.5)
By Charles Esseltine.
I suggest that you should use a large (9 inch or larger) piece of foil (Florist foil is the best in my opinion.), for your first model. You can make the model from just
about any paper (Kami, Washi, waxed, plain, etc...), but the model will tend of suffer paper spread. So foil is the best. And Florist foil is very forgiving. If you
make a mistke, I mean mistake, it can be undone, and most creases can be pressed out. Begin the model white side up.
1.) Fold and unfold.
2.) Fold and unfold just the corners.
3.) Fold and unfold just the corners.
4.) Fold and unfold.
5.) Fold and unfold.
6.) Flip over
7.) Fold and unfold. Then flip over.
8.) Fold the sides in. The corners will
form mini-preliminary bases.
9a.) Choose one corner for
the head.
10.) Fold into the
center line.
11.) Unfold one flap.
9b.) Fold the flap
to the tip.
12.) Squash fold.
13.) Fold it back.
14.) Repeat steps
11 - 13 on the other
side.
15. Petal fold.
16.) Fold the flap back
and forth.
17.) Unwrap the outer
layers. You will have to
partially unfold it to do
so. Refold the bottom.
18.) Squash fold.
19.) Petal fold. Now you
have a small Bird Base.
X
20.) Fold the other three corners as shown.
21.) Fold into
a preliminary
base. Watch
the X.
22.) With the X
layers in front, fold
the sides to the
center line. Repeat
behind.
23.) Fold the point down to meet
the edges formed in the last step.
24.) Sink the tip on the
line created by the last
fold. If you partially
unfold it, it will be
much easier.
25.) Open up the sides.
X
X
X
X
X
28.) Repeat on
the back, but
unfold the tail as
well. Flip over.
26.) Petal Fold
Front and Back
27.) Pull out the inner
edges. Taking care not
to unfold the head (X)
Press flat.
29.) The tail should look
like this. Flip over.
30.) Fold the layers of
the head together.
31.) Fold the top layers
to the center. Then
unfold.
32.) Squash fold
33.) Flip this layer back.
34.) Flip all of the layers
of the head, to the other
side.
35.) Repeat steps 31
through 33 on the other
side.
36.) Open the
layers of the head,
37a.) Fold the edges into
rabbit ears.
37b.) The completed
folds. Now flip over.
38.) Using the other side
as a guide for these
folds. Make a rabbit ear.
39.) Squash fold.
40.) Petal fold the tail.
41.) Inside reverse fold the wing outward.
Opening the wingtips as you do. The leading
edges will line up with line AB
42.) Fold the inner layer up on the front and back
of each wing.
A
B
[ Pobierz całość w formacie PDF ]